I'm trying to receive my remotes information with IR receiver and this is my code:

 /*
 * IRremote: IRrecvDemo - demonstrates receiving IR codes with IRrecv
 * An IR detector/demodulator must be connected to the input RECV_PIN.
 * Version 0.1 July, 2009
 * Copyright 2009 Ken Shirriff
 * http://arcfn.com
 */

#include <IRremote.h>

int RECV_PIN = 11;
IRrecv irrecv(RECV_PIN);
decode_results results;

void setup()
 {
  Serial.begin(9600);
  irrecv.enableIRIn(); // Start the receiver
}

void loop() {
  if (irrecv.decode(&results)) {
    Serial.println(results.value, HEX);
    irrecv.resume(); // Receive the next value
  }
  delay(100);
}

I try to upload this to Arduino and it says this:

exit status 1
redefinition of 'int RECV_PIN'

How can i fix this?

I'm trying to receive remote information with an IR receiver and this is my code:

#include <IRremote.h>

int RECV_PIN = 11;
IRrecv irrecv(RECV_PIN);
decode_results results;

void setup() {
  Serial.begin(9600);
  irrecv.enableIRIn(); // Start the receiver
}

void loop() {
  if (irrecv.decode(&results)) {
    Serial.println(results.value, HEX);
    irrecv.resume(); // Receive the next value
  }
  delay(100);
}

I tried to upload this to Arduino and it says:

exit status 1
redefinition of 'int RECV_PIN'

How can I fix this?

I'm trying to receive my remotes information with IR receiver and this is my code:

/*

• IRremote: IRrecvDemo - demonstrates receiving IR codes with IRrecv
• An IR detector/demodulator must be connected to the input RECV_PIN.
• Version 0.1 July, 2009
• Copyright 2009 Ken Shirriff
• http://arcfn.com */ #include <IRremote.h> int RECV_PIN = 11; IRrecv irrecv(RECV_PIN); decode_results results; void setup() { Serial.begin(9600); irrecv.enableIRIn(); // Start the receiver } void loop() { if (irrecv.decode(&results)) { Serial.println(results.value, HEX); irrecv.resume(); // Receive the next value } delay(100); }

I try to upload this to Arduino and it says this: exit status 1 redefinition of 'int RECV_PIN'

How can i fix this?

I'm trying to receive my remotes information with IR receiver and this is my code:

 /*
 * IRremote: IRrecvDemo - demonstrates receiving IR codes with IRrecv
 * An IR detector/demodulator must be connected to the input RECV_PIN.
 * Version 0.1 July, 2009
 * Copyright 2009 Ken Shirriff
 * http://arcfn.com
 */

#include <IRremote.h>

int RECV_PIN = 11;
IRrecv irrecv(RECV_PIN);
decode_results results;

void setup()
{
  Serial.begin(9600);
  irrecv.enableIRIn(); // Start the receiver
}

void loop() {
  if (irrecv.decode(&results)) {
    Serial.println(results.value, HEX);
    irrecv.resume(); // Receive the next value
  }
  delay(100);
}

I try to upload this to Arduino and it says this:

exit status 1
redefinition of 'int RECV_PIN'

How can i fix this?