Skip to main content
Arduino

Return to Question

added 98 characters in body
Source Link
Vraj P
Vraj P
  • 67
  • 1
  • 6

I have recently purchased a ESP-8266 HUZZAH by adafruit. I'm kind of new to the whole arduino concept. I would like to know how I would be able to utilise this breakout board with my Arduino to do anything. I have searched on the internet and I know about flashing the board. However, I have no idea how to flash this device. Some help would be appreciated.

I also have no idea where to put my pins. I know that there are RX and TX pins on the UNO, but those are at 0 and 1. Most online guides are using something like 11/12 or 2/3.

Here is the link to the product website

Thanks, Vraj

I have recently purchased a ESP-8266 HUZZAH by adafruit. I'm kind of new to the whole arduino concept. I would like to know how I would be able to utilise this breakout board with my Arduino to do anything. I have searched on the internet and I know about flashing the board. However, I have no idea how to flash this device. Some help would be appreciated.

I also have no idea where to put my pins. I know that there are RX and TX pins on the UNO, but those are at 0 and 1. Most online guides are using something like 11/12 or 2/3.

Thanks, Vraj

I have recently purchased a ESP-8266 HUZZAH by adafruit. I'm kind of new to the whole arduino concept. I would like to know how I would be able to utilise this breakout board with my Arduino to do anything. I have searched on the internet and I know about flashing the board. However, I have no idea how to flash this device. Some help would be appreciated.

I also have no idea where to put my pins. I know that there are RX and TX pins on the UNO, but those are at 0 and 1. Most online guides are using something like 11/12 or 2/3.

Here is the link to the product website

Thanks, Vraj

Source Link
Vraj P
Vraj P
  • 67
  • 1
  • 6

HUZZAH ESP-8266 (by ADAFRUIT): How to use with the ARDUINO R3

I have recently purchased a ESP-8266 HUZZAH by adafruit. I'm kind of new to the whole arduino concept. I would like to know how I would be able to utilise this breakout board with my Arduino to do anything. I have searched on the internet and I know about flashing the board. However, I have no idea how to flash this device. Some help would be appreciated.

I also have no idea where to put my pins. I know that there are RX and TX pins on the UNO, but those are at 0 and 1. Most online guides are using something like 11/12 or 2/3.

Thanks, Vraj