Skip to main content
Arduino

Return to Question

Made it a bit more useful if the link goes down, improved formatting a bit
Source Link
Anonymous Penguin
Anonymous Penguin
  • 6.4k
  • 10
  • 34
  • 62

I want to use one an push button with an led in middle, similar to this one on ebayeBay. The push button has a 12v input I want to hook it up to an arduino unoAduino Uno or nanoNano.

Is there a way to hook it up and receive the signal? I am not an expert.. more of a novice.

Specifications from the eBay page:

  • Latching type, push it—on, push it again — off
  • Switch Rating: 3A/250VAC
  • LED voltage: 12V only
  • Contact Configuration: 1NO1NC
  • Pin Number: 5

I want to use one an push button with an led in middle, similar to this one on ebay. The push button has a 12v input I want to hook it up to an arduino uno or nano.

Is there a way to hook it up and receive the signal? I am not an expert.. more of a novice.

I want to use one an push button with an led in middle, similar to this one on eBay. The push button has a 12v input I want to hook it up to an Aduino Uno or Nano.

Is there a way to hook it up and receive the signal?

Specifications from the eBay page:

  • Latching type, push it—on, push it again — off
  • Switch Rating: 3A/250VAC
  • LED voltage: 12V only
  • Contact Configuration: 1NO1NC
  • Pin Number: 5
Source Link
Peter Sun
Peter Sun
  • 145
  • 2
  • 5

Hooking up 12v Push button to arduino uno/nano

I want to use one an push button with an led in middle, similar to this one on ebay. The push button has a 12v input I want to hook it up to an arduino uno or nano.

Is there a way to hook it up and receive the signal? I am not an expert.. more of a novice.