Return to Revisions

This outputs 8 MHz on pin 9:

#ifdef __AVR_ATmega2560__
  const byte CLOCKOUT = 11;  // Mega 2560
#else
  const byte CLOCKOUT = 9;   // Uno, Duemilanove, etc.
#endif

void setup ()
  {
  // set up 8 MHz timer on CLOCKOUT (OC1A)
  pinMode (CLOCKOUT, OUTPUT); 
  // set up Timer 1
  TCCR1A = bit (COM1A0);  // toggle OC1A on Compare Match
  TCCR1B = bit (WGM12) | bit (CS10);   // CTC, no prescaling
  OCR1A =  0;       // output every cycle
  }  // end of setup

void loop ()
  {
  // whatever 
  }  // end of loop

How can add a prescaler?

You change the prescaler bits. You can look at the datasheet or my cheat sheet here:

You may not need a prescaler, depending on the frequency. Change OCR1A to some number between 0 and 65535 to slow it down.