hello guys is there someone who can help me with my first project. its basically about logic circuits.
by using tact switch and pull-up resistor to set the values to logical 1 or 0. the output can be verified by using a LED as an indicator. so the code goes like this:
//AND GATE
int pin2=1; //set pin2=1
int pin3=1; //set pin3=1
void setup()
{
pinMode(2,INPUT);
pinMode(3,INPUT);
pinMode(4,OUTPUT);
pinMode(11,OUTPUT);
pinMode(12,OUTPUT);
}
void loop()
{
pin2=digitalRead(2);
pin3=digitalRead(3);
if(pin2==1) //turn led on pin11 when pin2 =1 { digitalWrite(11,HIGH); } else { digitalWrite(11,LOW); }
if(pin3==1) ////turn led on pin12 when pin3 =1 { digitalWrite(12,HIGH); } else { digitalWrite(12,LOW); }
//TRUTH TABLE OF AND
if(pin2 && pin3)
{
digitalWrite(4,HIGH);
}
else
{
digitalWrite(4,LOW);
}
}
//OR GATE
int pin2=1;
int pin3=1;
void setup() { pinMode(2,INPUT); pinMode(3,INPUT); pinMode(4,OUTPUT); pinMode(11,OUTPUT); pinMode(12,OUTPUT); } void loop() { pin2=digitalRead(2); pin3=digitalRead(3);
if(pin2==1)
{
digitalWrite(11,HIGH);
}
else
{
digitalWrite(11,LOW);
}
if(pin3==1)
{
digitalWrite(12,HIGH);
}
else
{
digitalWrite(12,LOW);
}
//TRUTH TABLE OF OR
if(pin2 || pin3)
{
digitalWrite(4,HIGH);
}
else
{
digitalWrite(4,LOW);
}
}
//NAND GATE
int pin2=1;
int pin3=1;
void setup() { pinMode(2,INPUT); pinMode(3,INPUT); pinMode(4,OUTPUT); pinMode(11,OUTPUT); pinMode(12,OUTPUT); } void loop() { pin2=digitalRead(2); pin3=digitalRead(3);
if(pin2==1)
{
digitalWrite(11,HIGH);
}
else
{
digitalWrite(11,LOW);
}
if(pin3==1)
{
digitalWrite(12,HIGH);
}
else
{
digitalWrite(12,LOW);
}
//TRUTH TABLE OF NAND
if(!(pin2 && pin3))
{
digitalWrite(4,HIGH);
}
else
{
digitalWrite(4,LOW);
}
}
can you guys help me to run this in one sketch by using tact switch to select the logic gate to be tested or run? thank you in advance