HDL Coder with Custom IP Core

조회 수: 8 (최근 30일)
John
John 2025년 4월 2일
댓글: John 2025년 4월 10일
I was trying to add a custom IP core to my reference design and now when I run HDL workflow advisor using the hdl_led_blinking sample project as a starting point, it fails because it is unable to locate the IP core that it created. I don't understand why it would be unable to find its own IP core. I confirmed that there is a led_count_ip_hw.tcl file in hdl_prj/ipcore. Can someone provide some debugging suggestions. Thank you.
  댓글 수: 1
Sahas
Sahas 2025년 4월 7일
Hi @John,
Please share the exact error message that was shown in the result pane as well as the Target configurations that are selected. This would help me investigate further.

댓글을 달려면 로그인하십시오.

이 질문에 답변하려면 로그인하십시오.

채택된 답변

Sahas
Sahas 2025년 4월 9일
Hi @John,
There could be a number of reasons of why the project is unable to locate the IP core. You might get help from the following MathWorks documentation links on:
I hope this resolves the query!
  댓글 수: 1
John
John 2025년 4월 10일
I did get this work eventually but for some reason I had to add the IP core that HDL coder generated to the same directory as my custom IP core. Also, it did not seem to like relative paths in the tcl file that defines the custom IP core. I switched in absolute paths into the add_fileset_file directive in the tcl file and it seemed to work afterwards.

댓글을 달려면 로그인하십시오.

추가 답변 (0개)

카테고리

Help Center 및 File Exchange에서 Xilinx Zynq Platform에 대해 자세히 알아보기

태그

제품


릴리스

R2024b

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by