So I'm trying to use my UNO as an HID device. I followed this tutorial, flashed the firmware and got the UNO to be detected as an HID device.
However, I am still getting the error
'Keyboard' not found. Does your sketch include the line '#include '?
Here's the code -
/*
Copyright (c) 2014 NicoHood
See the readme for credit to other people.
Keyboard example
Press a button to write some text to your pc.
See official documentation for more infos
*/
// include HID library
#include <HID.h>
const int pinLed = 13;
const int pinButton = 8;
void setup() {
pinMode(pinLed, OUTPUT);
pinMode(pinButton, INPUT_PULLUP);
// Starts Serial at baud 115200 otherwise HID wont work on Uno/Mega.
// This is not needed for Leonado/(Pro)Micro but make sure to activate desired USB functions in HID.h
Serial.begin(115200);
// Sends a clean report to the host. This is important because
// the 16u2 of the Uno/Mega is not turned off while programming
// so you want to start with a clean report to avoid strange bugs after reset.
Keyboard.begin();
}
void loop() {
if (!digitalRead(pinButton)) {
digitalWrite(pinLed, HIGH);
// Same use as the official library, pretty much self explaining
Keyboard.println("This message was sent with my Arduino.");
Serial.println("Serial port is still working and not glitching out");
// simple debounce
delay(300);
digitalWrite(pinLed, LOW);
}
}
/*
Definitions:
KEY_LEFT_CTRL
KEY_LEFT_SHIFT
KEY_LEFT_ALT
KEY_LEFT_GUI
KEY_RIGHT_CTRL
KEY_RIGHT_SHIFT
KEY_RIGHT_ALT
KEY_RIGHT_GUI
KEY_UP_ARROW
KEY_DOWN_ARROW
KEY_LEFT_ARROW
KEY_RIGHT_ARROW
KEY_BACKSPACE
KEY_TAB
KEY_RETURN
KEY_ESC
KEY_INSERT
KEY_DELETE
KEY_PAGE_UP
KEY_PAGE_DOWN
KEY_HOME
KEY_END
KEY_CAPS_LOCK
KEY_F1
KEY_F2
KEY_F3
KEY_F4
KEY_F5
KEY_F6
KEY_F7
KEY_F8
KEY_F9
KEY_F10
KEY_F11
KEY_F12
KEY_PRINT
KEY_SCROLL_LOCK
KEY_PAUSE
*/
Can anyone point out what I'm doing wrong here?
