Multiple I2C Devices connected parallel

I have two Lidar Lites, connected to one APM. I have no issue with getting data from one of them, i use the code below

#include <I2C.h>
#define    LIDARLite_ADDRESS   0x62          // Default I2C Address of LIDAR-Lite.
#define    RegisterMeasure     0x00          // Register to write to initiate ranging.
#define    MeasureValue        0x04          // Value to initiate ranging.
#define    RegisterHighLowB    0x8f          // Register to get both High and Low bytes in 1 call.


void setup(){
  Serial.begin(9600); //Opens serial connection at 9600bps.     
  I2c.begin(); // Opens & joins the irc bus as master
  delay(100); // Waits to make sure everything is powered up before    sending or receiving data  
  I2c.timeOut(50); // Sets a timeout to ensure no locking up of sketch if I2C communication fails
}

void loop(){
 // Write 0x04 to register 0x00
  uint8_t nackack = 100; // Setup variable to hold ACK/NACK resopnses     
  while (nackack != 0){ // While NACK keep going (i.e. continue     polling until sucess message (ACK) is received )
    nackack = I2c.write(LIDARLite_ADDRESS,RegisterMeasure, MeasureValue); // Write 0x04 to 0x00
    delay(1); // Wait 1 ms to prevent overpolling
  }

  byte distanceArray[2]; // array to store distance bytes from read function

  // Read 2byte distance from register 0x8f
  nackack = 100; // Setup variable to hold ACK/NACK resopnses     
  while (nackack != 0){ // While NACK keep going (i.e. continue polling until sucess message (ACK) is received )
    nackack = I2c.read(LIDARLite_ADDRESS,RegisterHighLowB, 2, distanceArray); // Read 2 Bytes from LIDAR-Lite Address and store in    array
   delay(1); // Wait 1 ms to prevent overpolling
  }
  int distance = (distanceArray[0] << 8) + distanceArray[1];  // Shift high byte [0] 8 to the left and add low byte [1] to create 16-bit int

  // Print Distance
  Serial.println(distance);
}

i can get the distance fine, now have two connected, as follows

So my noob question is how to i get data from the 2, my guess is the wiring is ok.

I am using the code from https://github.com/PulsedLight3D/LIDARLite_v2_Arduino_Library

any help would be appreciated. thanks.