I tried to flatten an array with numbers into a variable in order to pass it as an input to a module in verilog. But, I get the error:
Port 1 (DATA_IN) of process_data expects 64 bits, got 4096. Pruning 4032 high bits of the expression.
I know that my module process_data in not ready yet and hence it does not work properly, but my problem for now is that the input is a lot more bits than it should. Do you know how could I fix it?
module process_data(input wire [63:0] DATA_IN , input wire [6:0]AdrR , input wire [6:0]AdrW, input R_W , input Cen, input clk, input reset, output reg [63:0]Reg_Data_Out);
integer i;
reg [63:0]Memory[63:0]; //64 * 64 bit array
initial
begin
i=0;
//++for
repeat (64)
begin
Memory[i]=64'd1; //64 = number of the thesis that the vector has
i=i+1;
end
end
always @(negedge(clk))
//initial AdrR ,AdrW = 0; // 7'b0000_000;
begin
if(Cen == 1'b1) begin // cen = chip enabled
case (R_W)
1'b1:
//++check if not empty
Reg_Data_Out = Memory[AdrR]; // (read) out put memory context
1'b0:
//++check if not full
Memory[AdrW] = DATA_IN; // write input to memory
default:
Reg_Data_Out = 64'bxxxxxxxx;
endcase
end
end
endmodule
module TOP();
reg [63:0] inputdata1 [0:127]; //array
reg [64*64-1:0] flattened_inputdata1;
reg [6:0] AddressR,AddressW;
reg cen,clk, R_W, reset;
wire [63:0] Data_Out;
//pass the numbers
integer count;
initial
begin
count = 0;
while (count < 128) // Execute loop till count is 127. exit at count 128
begin
// every timh that the integer variable count takes must be also passed into reg inputdata1
inputdata1[count] = count;
count = count + 1;
end
end
//flattening
initial
begin
count = 0;
while (count < 128) // Execute loop till count is 127. exit at count 128
begin
flattened_inputdata1[64*count +: 64] = inputdata1[count];
//flattened_inputdata1[(64*count) +63) : (64*count)] = inputdata1[count]; //declare a number is dekadikos
count = count + 1;
end
end
//call module for data I/O
process_data process_data( flattened_inputdata1, AddressR, AddressW, R_W , cen, clk, reset, Data_Out); //reset does not do anything yet
always #10 clk=~clk;
initial
begin
$display("flattenedinputdata1=%d", flattened_inputdata1);
cen=1'b1; //chip enabled
#50
R_W=1'b1; //read
AddressR=7'b0000_000;
#50
//R_W=1'b1; //read
//AddressR=7'b0000_001;
$finish; //#50 $finish;
end
endmodule
